![]() In this case geometric non linear analysis has to be carried and an elastic catenary behaviour of the cable is considered. More detailed analysis may require cable elements be m odelled. The model is checked if the stiffness of the truss is sufficient to resist the initial Dead load. Usage in Cable Bridges For preliminary design of the cable bridges we go for modelling of cables as equivalent truss elements. It's the job of the bridge design to handle these forces without buckling or snapping. ![]() suspension and cable-stayed bridges, where in large deformation effects can not be neglected. Compression and tension are present in all bridges, and as illustrated, they are both capable of damaging part of the bridge as varying load weights and other forces act on the structure. It’s effective in case of cable bridges i.e. General Usage Used for both cable bridges as well as for modelling struts and ties of general bridges. ![]() Non linear behaviour, no superimposition When non linear behaviour of cable is considered, superimposition of load cases are ruled out and combined effect of loads has to be considered. Load Combinations Superimposition possible Linear combinations of load cases can be made to compare truss force results. Hence consideration of sag becomes important. Sag is predominant Cable elements are inherently non linear and the stiffness changes with the load applied. Main differences in these elements are as tabulated below: Feature Truss Element Cable Element Sag Effect No Sag Truss element, is linear in general and has constant stiffness. Truss element can resist both tension and compression, while a cable element can resist only tension.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |